HVAC in Glen Ellyn, IL: furnace & AC repair, replacement, and maintenance

Furnace repair in Glen Ellyn

The winter call we get most is a furnace that won't fire on a cold morning. Nine times out of ten it's a flame sensor, a hot-surface igniter, or a condensate clog on a high-efficiency unit — all fixable on the first visit. The other pattern is a furnace that runs but can't keep up: usually a filter that ran too long, a dying blower motor, or a unit past its 15-year mark losing capacity. We diagnose for a flat fee, quote in writing before any work, and credit the diagnostic toward the repair.

Furnace replacement and new installations

When a repair stops making financial sense, we install Carrier, Lennox, Trane, Goodman, and Rheem furnaces — 80% AFUE where budget or venting demands it, 95%+ condensing units where the gas savings justify the cost. Every install is sized to the actual house with a load calculation, not copied off the old unit's sticker. Village of Glen Ellyn permit, final inspection, and manufacturer warranty registration are all handled by us.

AC repair, installation, and replacement

Glen Ellyn summers are humid, and central air that limps through July is miserable. We handle AC diagnostics and repair — capacitors, contactors, fan motors, refrigerant leaks — plus full system replacement when the math says so. If your system still runs on R-22, a failed compressor usually settles the repair-or-replace question on its own. Spring tune-ups (coil cleaning, refrigerant pressures, amp draws) catch most failures before the first heat wave.

Heat pumps and ductless mini splits

Cold-climate heat pumps now handle Chicago winters credibly, and pairing one with a gas furnace as a dual-fuel setup is often the cheapest way to heat a west-suburban home. Ductless mini splits solve the rooms your ductwork never reached — attic conversions, additions, sunrooms, the office over the garage. We size, install, service, and replace both.

HVAC maintenance and seasonal tune-ups

Two visits a year keep equipment alive: a fall furnace tune-up (burners, combustion and CO testing, flame sensor, filter, safety circuit) and a spring AC tune-up (coils, refrigerant, electrical). An hour each. If something is wearing out, you find out in October — not at 11 p.m. in January.

A local company that knows Glen Ellyn homes

We're headquartered on N Main St., so this isn't a territory on a franchise map — it's home. Glen Ellyn's housing stock runs from 1920s bungalows near downtown and the Metra station out to newer builds toward Stacy's Corners, and each era has its own quirks: undersized returns, furnaces wedged into closets, ductwork that was an afterthought. We've worked in all of them. And because heating, cooling, plumbing, and electrical are all in-house, the "furnace repair" that turns out to be a gas line or wiring problem doesn't need a second contractor.